Ford Escape 3.0 2001-2005 Right RH Axle Seal OEM YL8P7H260AA

Ford Escape 3.0 2001-2005 Right RH Axle Seal OEM YL8P7H260AA is a sealing component installed at the point where the axle shaft enters the transmission/differential assembly. The seal helps maintain sealing at the interface between the axle shaft and the driveline housing, reducing internal fluid leakage during vehicle operation.

During use, the axle seal is constantly exposed to the rotating motion of the axle shaft, heat, and lubricating fluid. Over time, the seal may harden, wear, or lose its sealing ability. When this happens, fluid may begin to leak around the axle end, causing oil buildup and reducing the amount of lubricant inside the driveline assembly.

Replacing the Ford Escape 3.0 2001-2005 RH YL8P7H260AA axle seal when signs of leakage appear helps restore sealing at the axle shaft location, limit fluid loss, and help protect the internal components of the driveline system.

Product Information

• Product name: Ford Escape right axle seal
• Vehicle line: Ford Escape
• Engine: 3.0L
• Model years: 2001-2005
• Position: Right side – RH
• Part number: YL8P7H260AA/ FW9027238 
• Brand: Ford
• Condition: OEM
• Application: Seals the axle shaft and driveline assembly

Function and Role

The axle seal plays an important role in sealing the axle shaft area, where the shaft rotates continuously while the vehicle is running. The seal helps prevent lubricating fluid inside the transmission/differential assembly from escaping, while also helping reduce the entry of dust and contaminants into the sealed area.

For the Ford Escape 3.0 2001-2005, the right RH axle seal is installed at the corresponding position in the driveline system. When the seal is in good condition, the area around the axle end stays sealed and the fluid level inside the system remains stable.

If the seal deteriorates and is not replaced, fluid leakage may become more severe. Low fluid levels can affect lubrication and the durability of internal driveline components.

Key Benefits

• OEM seal suitable for Ford Escape 3.0.
• Correct part number YL8P7H260AA.
• For the right-hand RH position.
• Designed to match the original sealing location.
• Helps reduce fluid leakage at the axle end.
• Supports maintaining the required lubricant level for the driveline assembly.
• Suitable for Ford Escape repair and maintenance.

Signs It Needs Inspection or Replacement

Inspect the axle seal if you notice:

• Signs of oil leakage around the axle end.
• Oil buildup on the transmission or differential area near the axle end.
• Oil stains under the vehicle.
• The seal has been in use for many years and shows hardening or deformation.
• The seal was damaged during axle removal or installation.
• The axle shaft has been removed for repair and the sealing component needs to be replaced.

👉 The Ford Escape 3.0 2001-2005 Right RH OEM YL8P7H260AA axle seal is a suitable replacement part when the old seal is worn or causing oil leaks. Replacing the seal with the correct part number and position helps ensure proper sealing, reduce fluid loss, and maintain stable driveline operation.

Replacement Recommendations

When replacing the YL8P7H260AA axle seal, check the axle shaft surface and seal installation area at the same time to ensure there are no scratches, wear, or unusual damage. Install the seal in the correct position and using proper technique to prevent leaks from returning after repair.

Before ordering, compare the Ford Escape 3.0 2001-2005 model year, right-hand RH position, and YL8P7H260AA part number to make sure you select the correct part.