Genuine Third Row Seat Fold Control Module for Ford Everest 2018-2021 EB3Z14F042D

Genuine third row seat fold control module for Ford Everest 2018-2021, part number EB3Z14F042D is an important electronic control unit for the PowerFold™ seat system, responsible for receiving signals from the control switch and controlling the third row seat fold/unfold motor to operate accurately. The module helps synchronize the folding and unfolding process while ensuring the protection and obstacle-detection functions work correctly as designed by Ford.

On the Ford Everest 2018-2021 equipped with power-fold third row seats, the control module works in sync with the control switch, seat fold motor, seat position sensors, wiring harness, fuse, and BCM (Body Control Module). When the system is operating normally, the user only needs to press a button to fold or unfold the third row seat quickly, smoothly, and safely. The system also integrates obstacle detection, helping stop and reverse seat movement when an obstruction is detected to limit damage and improve safety.

Product EB3Z14F042D is a genuine Ford part, manufactured to strict quality standards with a highly stable electronic control circuit, heat-resistant engineering plastic housing, and connectors built to vibration-resistant and moisture-resistant standards. The correct specification design allows precise installation on the Ford Everest 2018-2021 without modification or additional programming when replacing the correct part.

Over time, the control module may be damaged by short circuits, water ingress, corrosion at the connector pins, or electronic component failure. In that case, the third row seat may not fold or unfold, operate intermittently, work on only one side, or lose control function completely. If not fixed promptly, luggage space use may be affected and the seat fold motor may be overloaded.

Product EB3Z14F042D is manufactured to Ford genuine standards, ensuring stable control, high durability, and full compatibility with the original power-fold seat system on the Ford Everest 2018-2021.

Product Information

Product name: Third Row Seat Fold Control Module / Third Row Power Fold Seat Control Module
Part numbers: EB3Z14F042D/ EB3Z14F042C/ EB3T14F042AF
Brand: Genuine Ford

Applicable vehicles:

• Ford Everest 2018-2021 (version with power-fold third row seats)

Installation location: Third row seat control system
System: Body electrical system – PowerFold™ power-fold seats
Condition: New

Functions and role

• Controls the third row seat fold and unfold motor.
• Receives signals from the control switch.
• Synchronizes the operation of the power-fold seat system.
• Supports the obstacle detection function.
• Ensures the seat operates safely and accurately.

Key advantages

• Genuine Ford part.
• Stable electronic control circuit.
• Good vibration resistance, heat resistance, and moisture resistance.
• High compatibility with the original system.
• Installed to the manufacturer’s standard.

Signs it should be checked or replaced

• The third row seat will not fold or unfold.
• The seat operates intermittently or only one side works.
• No response when the control button is pressed.
• Power seat system error warning.
• The control module has water ingress or a burnt circuit.

👉 The third row seat fold control module is the control center of the PowerFold™ seat system, directly affecting convenience and luggage space usability. Using the genuine third row seat fold control module for Ford Everest 2018-2021, part number EB3Z14F042D, helps restore stable, safe, and Ford-standard power seat folding function.

Replacement recommendations

• Replace with the correct EB3Z14F042D part for the vehicle.
• Check the control switch, seat fold motor, and wiring harness at the same time.
• Check the fuse and power supply before replacing the control module.
• Do not allow water to enter the control module area.
• It is recommended to install and test with diagnostic equipment at a garage or repair center with expertise to ensure the power-fold seat system operates correctly.